EmBitz › EBlink › Using EBlink
st-link selection via serial

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
st-link selection via serial
resonantworks Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Sep 2020
Reputation: 0
#1
24-09-2020, 08:53 PM
Is it possible to choose the active debug probe which EBlink uses by serial number on the command line?
I usually have 3+ st-links connected at the same time since I work with hardware which has 3 separate stm32s which communicate with each other via uart.
Matthew.
Find
Reply


Messages In This Thread
st-link selection via serial - by resonantworks - 24-09-2020, 08:53 PM
RE: st-link selection via serial - by PDonchev - 28-09-2020, 07:56 AM
RE: st-link selection via serial - by PDonchev - 06-10-2020, 07:08 AM
RE: st-link selection via serial - by embitz - 06-10-2020, 10:42 AM
RE: st-link selection via serial - by vdaniel - 07-10-2020, 06:41 AM
RE: st-link selection via serial - by embitz - 07-10-2020, 02:42 PM
RE: st-link selection via serial - by embitz - 08-10-2020, 09:02 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)