Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
STM32G0B1xx/0C1xx support
#1
STM32G0B1xx/0C1xx support. The script should recognize a dual bank, but I haven't tested it.
No support for RAM/FLASH ECC. I had to pre-configure the OBs with STM32CubeProgrammer to avoid starting of the system bootloader. BOOT0 pin is shared with SWDCLK. These MCUs are not supported in ST-Link Utility software.


Attached Files
.script   stm32gx.script (Size: 8.41 KB / Downloads: 113)
.script   stm32-auto.script (Size: 6.18 KB / Downloads: 97)
Reply
#2
Yesss, a contribution Smile
Thanks, this was the whole point of using scripts.

I will add it to the next release.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)