Full Version: STM32G0B1xx/0C1xx support
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
STM32G0B1xx/0C1xx support. The script should recognize a dual bank, but I haven't tested it.
No support for RAM/FLASH ECC. I had to pre-configure the OBs with STM32CubeProgrammer to avoid starting of the system bootloader. BOOT0 pin is shared with SWDCLK. These MCUs are not supported in ST-Link Utility software.
Yesss, a contribution Smile
Thanks, this was the whole point of using scripts.

I will add it to the next release.