Hello
I tri to use EBLink with an ST-Link2 connected to an old Arduino Due (Atmel SAM3X8E)
When starting EBlink it seems to detect a Cortex M3, which is correct. But then there is an error:
"Can't detect MCU vendor"
There is also a message to eventually disable the "dr" option, but this has no effect (I started both the stm32gdg and stm32hotplug versions)
How can I get the ST-Link to accept non ST hardware?
I tri to use EBLink with an ST-Link2 connected to an old Arduino Due (Atmel SAM3X8E)
When starting EBlink it seems to detect a Cortex M3, which is correct. But then there is an error:
"Can't detect MCU vendor"
There is also a message to eventually disable the "dr" option, but this has no effect (I started both the stm32gdg and stm32hotplug versions)
How can I get the ST-Link to accept non ST hardware?