Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
F7/F4 flash errors [solved]
#1
I have 2 projects in C++ I'm working actively at this time, and they are for debugging my graphic library.

STM32F746G-DISCO
and
STM32F4DISCOVERY

I'm using the built-in St-link on both of them!
Project can be downloaded without problem with 1.11 and work like a charm..

But with 2.3 and EB-Link 4.5
I get those error (Please note the sector is always at random)
I'm running Windows 10.  I Have uninstall Embitz and the EB-Link and have reinstalled them. Problem is persisting.

I also noticed that debugging is slower than it was with 1.11 and EB-link

Thank for any tips!!


Attached Files Thumbnail(s)
       
Reply
#2
I can only look at this if I have a (small) project with this bug.

Could you share a project with the error?

That EB1.11 is faster is not explainable by the application because that engine is the same as 2.x.
Perhaps going back to older GCC toolchains would make a difference in speed (perhaps .elf info level changes).
Reply
#3
I did some tests with EBlink and CubeIDE for some F4DISCO demonstration code and I can't reproduce this.
What is the firmware version of the STlink's on the boards?
Reply
#4
To close this subject, those 2 projects were on the sideline for sometimes... but I came back to them as I needed to to advance my library..

Finally found the .... problem.... I just needed to update the St-link software in the embedded probe so they can work with the driver from Win10 and Win11.. my old windows 8 machine had the previous driver working OK with ST old PC Driver
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)