EmBitz › EBlink › Using EBlink
STLink-V3MINI usage

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
STLink-V3MINI usage
vdaniel Offline
Junior Member
**
Posts: 28
Threads: 9
Joined: May 2020
Reputation: 0
#5
17-03-2021, 09:20 AM (This post was last modified: 17-03-2021, 09:25 AM by vdaniel.)
(17-03-2021, 01:53 AM)john.rudolph.ee Wrote:
(05-03-2021, 02:17 PM)vdaniel Wrote:
(05-03-2021, 10:17 AM)embitz Wrote: Jump wiring the VCC sense input at the dongle is no solution?

Hi,

Unfortunately, STLink-V3MINI has not 5V or 3.3V outputs.  So nowhere to jump.

vdaniel
As I understand you have shorted pin 3 (T_VCC input) to pin 5 (GND).
I do not think, that it is a good solution.
Find
Reply


Messages In This Thread
STLink-V3MINI usage - by vdaniel - 04-03-2021, 09:34 AM
RE: STLink-V3MINI usage - by embitz - 05-03-2021, 10:17 AM
RE: STLink-V3MINI usage - by vdaniel - 05-03-2021, 02:17 PM
RE: STLink-V3MINI usage - by john.rudolph.ee - 17-03-2021, 01:53 AM
RE: STLink-V3MINI usage - by vdaniel - 17-03-2021, 09:20 AM
RE: STLink-V3MINI usage - by embitz - 18-03-2021, 09:13 AM
RE: STLink-V3MINI usage - by vdaniel - 18-03-2021, 01:31 PM
RE: STLink-V3MINI usage - by vorosj - 26-03-2021, 04:36 AM
RE: STLink-V3MINI usage - by john.rudolph.ee - 27-03-2021, 06:05 PM
RE: STLink-V3MINI usage - by embitz - 27-03-2021, 07:48 AM
RE: STLink-V3MINI usage - by embitz - 28-03-2021, 08:43 AM

Forum Jump:


Users browsing this thread: 2 Guest(s)