Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Debugging "Next line"
#1
Sometimes there is a problem with the "Next Line" command at the end of loops. EmBitz does not stop the execution of the code. This usually happens with optimized code, but in the attached project the problem can be reproduced with "Debug" target.
This is not a problem with Eblink because I have the same problem with other gdb servers.
EmBitz version 2.41.


Attached Files
.zip   gdb_test.zip (Size: 162.22 KB / Downloads: 78)
Reply


Messages In This Thread
Debugging "Next line" - by PDonchev - 09-06-2022, 11:14 PM
RE: Debugging "Next line" - by embitz - 19-06-2022, 04:21 PM
RE: Debugging "Next line" - by PDonchev - 20-06-2022, 07:17 PM
RE: Debugging "Next line" - by embitz - 21-06-2022, 09:27 AM
RE: Debugging "Next line" - by PDonchev - 21-06-2022, 10:14 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)