Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EBlink doesn't connect
#1
Hello, I try to connect to ATSAMC21 MCU using EBlink but without success.


Here are project settings:
[Image: eblink.png]

And this is a log:

Code:
EBlink version 4.7-[13] by Gerard Zagema

Using EB_SCRIPT_PATH = C:\Program Files (x86)\EBlink\scripts

Interface      : STlink
Device found at bus 1:28
Interface USB# : 55FF6C064883545237160887
Interface at  1:28 - <BUS>:<ADDR>
Interface type : STlink/V2
STlink Frmware : V2.J29.S7
STlink connect : Under reset
Unknown/unexpected STLINK status code 0x9
STlink connect : Try again with active reset
Unknown/unexpected STLINK status code 0x9
STlink connect : connect under reset failed, try without reset
Error initializing interface STlink
Target power perhaps?
STlink connect : Hot plugging
Unknown/unexpected STLINK status code 0x9
Target voltage : 3.23V


The PCB is definitely connected and powered, ST-Link is also Ok, I have tested it.

What could be wrong here?
Reply


Messages In This Thread
EBlink doesn't connect - by Polarisru - 01-02-2023, 03:04 PM
RE: EBlink doesn't connect - by embitz - 17-03-2023, 07:55 AM
RE: EBlink doesn't connect - by Polarisru - 17-03-2023, 04:25 PM
RE: EBlink doesn't connect - by embitz - 17-03-2023, 07:26 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)