Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
EBlink-Error, Voltage too low! with break-away nucleo probe
#8
Ah ok, yes I missed that completely. I changed the title.

Well, EBlink doesn't measure but the STlink firmware is doing so. And your STlink is reporting to EBlink that it supports target voltage measurements so EBlink is asking the probe "well, if you support voltage feedback, please give it to me!" and the STlink reports back "0.01V".

The STlink is using PA0 for the measurement as far as I can see. In your link there is a bridge SB11.
But I personally never used a break-away board from a nucleo so I don't have any experiences with how to use these as standalone debugger.
Reply


Messages In This Thread
RE: EBlink-Error, Voltage to low! - by embitz - 19-06-2022, 05:15 PM
RE: EBlink-Error, Voltage to low! - by Salamander - 20-06-2022, 10:37 PM
RE: EBlink-Error, Voltage to low! - by embitz - 21-06-2022, 10:23 AM
RE: EBlink-Error, Voltage to low! - by Salamander - 21-06-2022, 08:57 PM
RE: EBlink-Error, Voltage to low! - by embitz - 22-06-2022, 01:06 PM
RE: EBlink-Error, Voltage to low! - by Salamander - 22-06-2022, 06:34 PM
RE: EBlink-Error, Voltage to low! - by embitz - 22-06-2022, 09:26 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)