+- Forums (https://www.embitz.org/forum)
+-- Forum: EmBitz - Public (https://www.embitz.org/forum/forum-16.html)
+--- Forum: EmBitz IDE (https://www.embitz.org/forum/forum-3.html)
+--- Thread: emBitz, MK66, Debugger and Source Code Syncing (/thread-949.html)
emBitz, MK66, Debugger and Source Code Syncing - Workalot - 21-11-2018
Have built a project based on NXP's MK66 MCU. I can download the program but the debugger brings up the wrong C source code (normally it would be the reset handler function or the main() function).
The Disassembly window however does show stepping through the reset handler code.
"Debug->Interfaces->GDB server.Device family: generic".
"Debug->Interfaces->GDB server->Settings->Connect/Reset: -select USB -device MK66FN2M0xxx18 -if SWD -speed auto".
"Debug->Interfaces->GDB server->Settings->After connect: monitor reset <cr> load".
Even tried "Debug->Interfaces->GDB server->Settings->Before connect: dir ..\Source" to locate the startup file and main.c.
Workalot.
RE: emBitz, MK66, Debugger and Source Code Syncing - Workalot - 27-11-2018
So that it is recorded...
A blank project was created and source files were added. Machinations moved source code around to other folders and this may have caused loss of tracking - don't know - the project file (.epb) seemed ok.
Anyway, the project was deleted and a new blank project created. Source files were then added from the desired folders. And we got to go!
Workalot